User's Manual

ManualsBrandsXsens Technologies ManualsElectronicsWireless Awinda Dongle

101

102

103

104

105

106

107

108

109

110

Document MV0319P.N

MVN User Manual

Problem

Solution

See Section 19.13 for the specification of the recommended computer

system.

During recording, the

rotations of some segments

do not correspond with the

3D character.

Check if MT’s have not moved in the suit. Perform a new calibration.

Move calmly for 10-20 seconds directly after calibration.

Check for magnetic disturbance (Section 19.2).

Stand still and perform a Character Reset (Ctrl+Alt+F).

During recording, the

rotations of some segments

are not smooth.

Check wireless connection.

Sensors clipped. Use ‘Correct sensor clipping data on reprocess’

option in >Options >Preferences >General >Recordings. Reprocess

file.

Check for magnetic field disturbance (Section 19.2).

Stand still and perform a Character Reset (Ctrl+Alt+F).

With MVN Awinda:

Change the radio channel (See 19.12.1)

Verify that this is also the case with a saved and reprocessed file

(which will also contain retransmitted data)

Graphical performance of

MVN Studio is poor; update

of image is slow

Set display frame rate to the same rate as the update rate in the

preferences menu.

Avatar/ system drops from

MVN Studio

This may be due to network configurations. Uninstall the network driver

for the active Ethernet connection (through your device manager) then

reinstall.

With MVN Awinda

there appears to be a large

latency

Change the radio channel. (See 19.12.1)

MTw LED shows

dual blink pattern

This does not happen often, if it does it means that the MTw has

crashed. To restore to normal, switch it off, by pressing the button for

6s. Press it for 1s to turn it back on.

When connecting 2

or more MVN Awinda

systems, MTw’s assign to

the wrong awinda station

Begin by connecting one Awinda station and turn on the MTw’s for the

system associated with this receiver. Select the system under

Accepted Systems and change the Wifi Radio channel in the Hardware

Status window to allow all of the MTw’s to connect.

Once the system is detected, repeat this process with the second and

additional systems.