User Manual

© Xsens Technologies B.V.
75
Press Record in MT
Manager, the button is
depressed and the
Noraxon software
indicates that recording
has started.
Repressing record in MT
Manager will stop the
recording on both
systems, where Noraxon
will again indicate waiting
for start trigger.
11.8.5.4 Awinda Station Receives Sync Signal (Noraxon Sends Sync Signal)
For the Xsens system to send the synchronisation commands, the mini-receiver from
Noraxon is not needed.
Hardware requirements:
Noraxon Hardware
Xsens Hardware
 Wireless EMG transmitters
 1 TeleMyo DTS (plus antenna)
 1 TeleMyo mini-receiver (plus antenna)
 MTw
 Awinda Station
Both systems of course also need related cables to connect to each other (with BNC
connectors at each end) and a USB cable to connect to the PC.
In addition to the normal MTw hardware setup, set up the hardware of the Noraxon system
as follows:
USB port of TeleMyo mini-receiver to USB of PC.
Connect jack connector to Sync Out port of TeleMyo mini-receiver to BNC connection Sync In
1 of Awinda Station.