User Manual

© Xsens Technologies B.V.
69
Select Start Recording
Check the check box for
Line 1
Polarity: Rising Edge
1
Trigger Once: Unchecked
2
Skip First = 0
Skip Factor = 1 (so that
every other pulse will start
a recording in MT
Manager)
Select Stop Recording
Check the check box for
Line 1
Polarity: Rising Edge
Check the check box for
Trigger Once: Unchecked
Skip First = 1 (first trigger
starts recording, so it
should not also send a
signal to stop - or this
causes confusion for
Awinda Station)
Skip Factor = 1 (so that
every other pulse will stop
a recording in MT
Manager)
The above example indicates how to allow a signal of 3.3V enter the Sync In 1 port, of the
Awinda Station. The first upward going pulse (and subsequent odd numbered pulses),
received on the Awinda Station, will start recording (Polarity = rising edge). The second
upward going pulse (and subsequent even numbered pulses), received on the Awinda
Station, will stop recording.
11.8.2 Start and stop recording of third party devices with infinite pulse width
It is of course also possible, to configure that for example the upward rising edge causes the
start of recording and the negative direction edge causes stop recording, this may be useful
in the event that a third party devices sends a pulse of infinite length.
To do this, the following settings should be input:
1
Note that this setting depends on the signal from third party system.
2
To ensure that a series of recordings can be made.