User Manual

© Xsens Technologies B.V.
25
State
Transition
Description
Next State
Connecting
Station
detected
MT Manager and Station are connected.
Connected
Connected
Enable
User indicated that the system can be
enabled.
Enabled
Enabled
Make
operational
User indicated that system can become
operational.
Operational
Disable
User indicated that the system is to be
disabled.
Connected
Operational
Start
measuring
User indicated that the system can start
measuring.
Measuring
Release
User indicates that system is no longer
operational, but still enabled.
Enabled
Measuring
Stop
measuring
User indicates that measuring can be stopped.
Operational
Start recording
User indicates that the recording is to be
started.
Recording
Recording
Stop recording
User indicates that the recording can be
stopped.
Measuring
It is possible to enable and disable the radio link using the wireless configuration window.
Likewise, rejecting and accepting motion trackers for a given Awinda Station.
6.5.1 Setting Up a Wireless Network in MT Manager
NOTE: If synchronisation with third party devices is needed first enable these settings (See
section 6.7) before carrying out the wireless configuration.
To configure the wireless network to be used, including selection of MTw’s, and the update
rates, go to > Tools > Wireless Configuration, or use the shortcut button:
As shown above, the wireless configuration menu is split into two sections:
1. On the left hand side are details about the detected Awinda Master(s). Here also the
Update Rate and the Radio Channel, per Awinda Master can be configured.
2. On the right hand side are details about the MTw and the associated radio signal
strength.