XB4 4WD Buggy Kit - Manual

3. FRONT SUSPENSION
KICK UP
ROLL CENTER
TRACK-WIDTH
DIRTCARPET
20
The tables describe the amounts of adjustment using the center and outside positions of the eccentric bushings.
The middle position eccentric bushings allow for finer adjustment increments.
The track-width is directly influenced by the size of the
wheels and tires used.
KICK-UP
TRACK-WIDTHROLL CENTER
FF
FFFF
FR
FRFR
(°)
(mm) (mm)
=7°
=6°
=8°
=6°
=5°
=7°
=8°
=7°
=9°
=
+
0.75mm
=
0mm
=
-
0.75mm
=
+
1.5mm
=
0mm
=
-
1.5mm
KICK-UP
C-HUB CASTER
10°
12° 13° 14° 15° 16°
15° 16° 17° 18° 19°
Caster is the angle between the steering pivot
axis and the vertical plane. Caster is affected not
only by the C-Hub caster, but also by the front
kick-up angle relative to the flat chassis bottom.
The table indicates how kick up angle effects
total caster.
The XB4’s stock caster blocks are 9°, but
blocks are available as an option.
TOTAL CASTER
=
C-HUB CASTER
+
KICK UP
The XRAY alu front lower suspension holders provide great range of adjustment for the front suspension. Using different combinations of eccentric bushings, fine adjustment of front kick-up, roll-center, and front
track-width can be obtained. For more information about the influence of kick-up, front track-width, and roll centers on car handling, please refer to HUDY Set-up Book (#209100).
903312
SFH M3x12
If the suspension arm does not move freely use a
HUDY Arm Reamer to size the holes of the arms .
Arm Reamer 3.0mm
(HUDY #107633)
ECCENTRIC BUSHINGS HAVE TWO DIFFERENT OFFSETS FROM THE CENTER.
Middle position = 0.5° or 0.375mm from center.
Outer position = 1° or 0.75mm from center.
FRONT ARM
L=R
2mm
2mm
From Front Arm
SHIM 3x6.5x2
Check for free movement.
DETAIL
SHORT FRONT SUSPENSION ARM
#362112 MEDIUM OPTION
#362112-H HARD INCLUDED
#362112-G GRAPHITE OPTION
LONG FRONT SUSPENSION ARM
#362113-H HARD OPTION
#362113-G GRAPHITE OPTION
Composite eccentric bushings
DIRT
0.5°
INITIAL SETTING
CARPET
Composite eccentric bushings
0.5°
INITIAL SETTING
CARPET
DIRT