Manualshelf

XRA350013 XB8 2018 Nitro Buggy Manual

ManualsBrandsXRAY ManualsCars & TrucksXB8 2018 Spec 1/8 Off-Road Nitro Buggy Kit
39404142434445464748
41
Fill the shock body with shock
oil up to the top. Make sure to
use same viscosity shock oil as
is in the shock.
➋
Orient the filled shock
vertically for several minutes
with the shock shaft fully
extended. The remaining air
bubbles will release.
Gently place the shock cap
assembly onto the filled shock
body. Excess oil will spill from
the shock.
➌
➍
50%
HALF TIGHTEN
Push the shock shaft 50% into
the shock body. Excess oil will
bleed thgrough the hole in the
shock cap.
Keep the shock shaft pushed
50% into the shock body
and tighten the shock cap
completely.
The rebound will be at
approximately 50%.
➍
Gently place the shock cap assembly onto the filled
shock body. Keep the shock shaft extended 100% from
the shock body and tighten the shock cap completely.
The rebound will be at approximately 100%.
➎ ➏
TIGHTEN FULLY
100%
50%
The default shock rebound setting is 0% (as described on page 40).
Alternatively, you may set the shock rebound setting to 50% or 100% as described below. Remove the shock springs before performing shock rebound adjustment.
Fill the shock body with shock oil up to the top.
Make sure to use same viscosity shock oil as is
in the shock.
➋
Orient the filled shock vertically for several
minutes with the shock shaft fully extended.
The remaining air bubbles will release.
➌
TIGHTEN FULLY
100%
50%
100%
SHORT front shock
LONG rear shock
IMPORTANT!
Both front shocks
must be the same
overall length.
IMPORTANT!
IMPORTANT!
Both rear shocks
must be the same
overall length.
FRONT SHOCKS
2x
REAR SHOCKS
FRONT & REAR SHOCKS
2x
SHORT spring
LONG spring
SETTING THE SHOCK REBOUND TO 50% (MEDIUM REBOUND)
11. SHOCK ABSORBERS
➊
Extend the shock shaft completely
and remove the shock cap.
REMOVE SHOCK CAP
SETTING THE SHOCK REBOUND TO 100% (HIGH REBOUND)
ALTERNATE SHOCK REBOUND SETTING (50% AND 100%)
➊
Extend the shock shaft completely and remove
the shock cap.
REMOVE SHOCK CAP
REAR shock PRELOAD
FRONT shock PRELOAD
approx. 2mm
approx. 2mm
DETAIL
SPRING RATE
SHOCK PRELOAD
RIDE HEIGHT
BOOK
SET-UP