XRA350013 XB8 2018 Nitro Buggy Manual

11
2. REAR TRANSMISSION
940816
BB 8x16x5
980314
P 3x14
901404
SB M4x4
Apply oil from inside to prevent
breakage of the rubber boot.
Graphite Grease
(HUDY #106210)
NOTE
ORIENTATION
LONG CVD DRIVE SHAFT
Cut on both front and
rear bulkhead blocks
BEFORE inserting the clip on the central CVD shaft joint, apply a small amount of
threadlock on the area where the clip goes.
AFTER inserting the clip on the central CVD shaft joint, turn the clip so that the slot is
90°from the pin. This will prevent the pin from opening the clip.
Follow the TECH TIP on page 5
for drive shaft pin servicing.
DETAIL
DETAIL
DETAIL
BAG
➊
➊
➋
➋
➌
➌
➍
➍
STEP DETAIL
➎
355005
REAR DIFF
908312
352006 XB8’16 DIFF BULKHEAD BLOCK SET FRONT/REAR
355005 XB8 REAR DIFFERENTIAL 46T - V2 - SET
353053 XB8 ALU REAR SHOCK TOWER - CNC MACHINED 7075 T6 (4MM)
355114 BEVEL DRIVE GEAR 14T
355236 CVD DRIVE SHAFT COUPLING - HUDY SPRING STEEL™
355416 CENTRAL CVD SHAFT UNIVERSAL JOINT - HUDY SPRING STEEL™
355625 REAR CENTRAL CVD DRIVE SHAFT - HUDY SPRING STEEL™
➎
➎
➎
LONG
Graphite Grease
(HUDY #106210)
REAR DIFF
3000cSt
The ring can be assembled by hand,
but for easy disassembly we recommend
using snap ring pliers (HUDY #189040)
Push joint against gear to remove gap.
Tighten setscrew onto gear flat spot.
908312
355472
355471
355625
355236
355416
352006
355114
352006
353053
980314
901404
940816
940816
PIN
STEP DETAIL
➍
step 1 step 2
step 3
OIL
355471 DRIVE SHAFT LOCKING RING (2)
355472 DRIVE SHAFT BOOT (2)
901404 HEX SCREW SB M4x4 (10)
908312 HEX SCREW SOCKET HEAD CAP SCH M3x12 (10)
940816 HIGH-SPEED BALL-BEARING 8x16x5 RUBBER SEALED (2)
980314 PIN 3x14 (10)
#355626
REAR UNIVERSAL CENTRAL DRIVE SHAFT - HUDY SPRING STEEL™ - SET
step 4
Use HUDY Ball-Bearing Grease
#106220 - STANDARD
#106221 - BLUE
#106222 - RED
908312
SCH M3x12