XRA360006 XRAY XB4 2019 Manual

32
6. SLIPPER CLUTCH ASSEMBLY
SLIPPER CLUTCH ADJUSTMENT
The Slipper Clutch can be adjusted by loosening the set-screw and then, while keeping the
tool inside of the set-screw, rotating the spur gear by hand as indicated in the drawing.
To LOOSEN: Rotate the spur gear in the counterclockwise (CCW) direction.
To TIGHTEN: Rotate the spur gear in the clockwise (CW) direction.
When tightening the set-screw again, ensure that the set screw sits only
on the flat spot of the shaft.
NOTE ORIENTATION
IMPORTANT
➊
➋
➌
Untighten set-screw
Adjust
Tighten set-screw
➋ ADJUST
TIGHTEN SLIPPER CLUTCH
903308
SFH M3x8
902308
SH M3x8
Allen 1.5mm
LOOSEN SLIPPER CLUTCH