XRA370010 X12 2019 Pan Car US & EU Manual

8
RIDE HEIGHT
RIDE HEIGHT
TRACK-WIDTH
The thickness of shims used
affects the ride height of the
car, so determine the proper
amount of shimming based
on tire diameter.
Moves freely
2x
2x
0.5mm
0.5mm
0.2mm
0.2mm (4x)
OIL
use HUDY Silicone Oil
LOW traction & bumpy track
10K cSt (#106510 HUDY 50ml)
HIGH traction & smooth track
30K cSt (#106530 HUDY 50ml)
Use the proper matching bushings to achieve the desired front track-width
LEFT RIGHT TRACK-WIDTH
-1mm
-0.5mm
0mm
+0.5mm
+1mm
169mm
168mm
167mm
166mm
165mm
+
=
The X12 has adjustable front track-width. There are 3 different bushings - 0mm centric (included
in kit), or 0.5mm or 1.0mm eccentric (optional). Use the same bushing in front and rear, and also
use the same (mirrored) orientation of the bushing on both right and left sides.
FRONT COIL SPRINGS - SOFT
#372176 C=1.5 GOLD OPTION
#372177 C=2.0 SILVER OPTION
#372178 C=2.5 BLACK OPTION
#372179 C=3.0 GREY OPTION
FRONT COIL SPRINGS
#372180 C=3.5 GOLD INCLUDED
#372181 C=4.0 SILVER OPTION
#372182 C=5.0 BLACK OPTION
#372183 C=5.5 GREY OPTION
ALU ECCENTRIC BUSHINGS
#372316-O 0mm INCLUDED
#372317-O 0.5mm OPTION
#372318-O 1.0mm OPTION
Arm Reamer 3.0mm
3.0 mm
The front suspension parts
were updated to eliminate
play to ensure better steering
performance. The updated holes
in the steering blocks may cause
a tighter fit of the kingpin in the
steering block; it is important that
the steering block moves freely
but without excessive play. If the
kingpin does not insert into the
steering block easily, use a 3mm
arm reamer to enlarge the hole.
Be very careful to remove only
enough material so you can insert
the kingpin without a lot of force.
1. FRONT SUSPENSION
372290
S 3.2x4.8x0.5
964032
S 3.2x4.8x0.2
965019
C 1.9
903312
SFH M3x12
(INITIAL SETTING)
ALTERNATIVE FRONT POSITION
Long wheelbase
ALTERNATIVE REAR POSITION
Short Wheelbase
FRONT WHEELBASE ADJUSTMENT
This position has the same wheelbase as the previous
X12 car as recommended for bigger tracks and tracks
with longer sweepers.
Shorter wheel base allows the car to rotate better right
in the center of the corner to maintain corner speed and
therefore it is recommended to use on tight technical tracks
or tracks with many 180 degree corners
RIDE HEIGHT ADJUSTMENT
INITIAL SETTING
above upper arm (0.5mm)
above steering block (1.3mm)
below steering block (0.2mm)
INITIAL SETTING
0.6mm washer (#372294 - GOLD)
The number of washers used
affects the ride height of the car,
so determine the proper amount of
shimming based on tire diameter.
DETAIL
INITIAL SETTING