XRA370010 X12 2019 Pan Car US & EU Manual

23
The floating servo mount eliminates unwanted tweak, and also
allows you to adjust any 1/12 servo to the centerline of the chassis.
The position of the servo depends on the weight of the electronics. If
the car is heavier on the right, use a left-side servo position; if the
car is heavier on the left, use a right-side servo position.
CENTER
306219
SHIM 3x6x3
SHORT
LONG
ALTERNATIVE 1 (INITIAL SETTING)
LONG SHOCK
ALTERNATIVE 1
LONG SHOCK
- FORWARD MOUNT POSITION
(INITIAL SETTING)
INITIAL SETTING
"LONG SHOCK"
"SHORT SHOCK"
ALTERNATIVE 2
SHORT SHOCK
ALTERNATIVE 2
SHORT SHOCK
- REARWARD MOUNT POSITION
3x6x2mm
3x6x2mm
BLACK nut M3 BLACK nut M3
The length of the shock absorber affects the amount of
rear downstop. To adjust, thread the ball-joint on or
off the bottom spring cap or adapter.
DOWNSTOP ADJUSTMENT
5mm
5mm
Press the collar FULLY onto
the end of the shock shaft and
tighten the M3x3 setscrew.
Press the collar FULLY onto the end of the
shock shaft and tighten the M3x3 setscrew.
LONG SHOCK (INITIAL SETTING) SHORT SHOCK
For the LONG shock alternative,
use the shock adaptor.
An innovative new feature is to change the center
shock length (and front mounting position). By using
longer or shorter shock, the damping and steering
characteristics can be changed.
LONG SHOCK (INITIAL SETTING):
Shock is built WITH adaptor.
Front mount is FORWARD.
Improves driveability over bumps, improves on-power
traction.
SHORT SHOCK:
Shock is built WITHOUT adaptor.
Front mount is REARWARD.
Improves steering response, quicker direction changes.
For initial setting, thread fully.For initial setting, thread fully.
ADAPTOR
DETAIL
DETAIL
6. FINAL ASSEMBLY
901303
SB M3x3
306219
SHIM 3x6x2
960032
N M3
902308
SH M3x8
903306
SFH M3x6
Use these shims only when you use INLINE ALIGNMENT
battery configuration.
NOTE
3x6x3mm
3x6x3mm