XRA370010 X12 2019 Pan Car US & EU Manual

1. FRONT SUSPENSION
RIDE HEIGHT
12
FRONT COIL SPRINGS - SOFT
#372176 C=1.5 GOLD OPTION
#372177 C=2.0 SILVER OPTION
#372178 C=2.5 BLACK OPTION
#372179 C=3.0 GREY OPTION
FRONT COIL SPRINGS
#372180 C=3.5 GOLD INCLUDED
#372181 C=4.0 SILVER OPTION
#372182 C=5.0 BLACK OPTION
#372183 C=5.5 GREY OPTION
2x
Arm Reamer 3.0mm
3.0 mm
The front suspension parts were updated to eliminate play
to ensure better steering performance. The updated holes
in the steering blocks may cause a tighter fit of the kingpin
in the steering block; it is important that the steering block
moves freely but without excessive play. If the kingpin does not
insert into the steering block easily, use a 3mm arm reamer
to enlarge the hole. Be very careful to remove only enough
material so you can insert the kingpin without a lot of force.
2x
Marked "R"
Marked "L"
3x6x2mm
3x6x1mm
NOTE
ORIENTATION
DETAIL
ALU NUTS M3
#296530-B ALU BLUE OPTION
#296530-K ALU BLACK OPTION
#296530-O ALU ORANGE OPTION
#960031 ALU SILVER INCLUDED
3. REAR SUSPENSION
372290
S 3.2x4.8x0.5
964032
S 3.2x4.8x0.2
965019
C 1.9
960031
ALU N M3
303122-O
SHIM 3x6x1
303123-O
SHIM 3x6x2
The flat of the nut must be PARALLEL
to the lower arm.
NOTE
ORIENTATION
Moves freely
OIL
use HUDY Silicone Oil
LOW traction & bumpy track
10K cSt (#106510 HUDY 50ml)
HIGH traction & smooth track
30K cSt (#106530 HUDY 50ml)
0.5mm (2x)
0.2mm (5x)
The thickness of shims used affects
the ride height of the car, so
determine the proper amount of
shimming based on tire diameter.
The thickness of shims changes the steering linkage
angle. Thicker shims gives decreased in-corner
steering, but car becomes easier to drive.
Use 3mm bump steer as INITIAL SETTING.
RIDE HEIGHT ADJUSTMENT
INITIAL SETTING
above upper arm (2.0mm)