instructions - Series 3

Before fitting the system to the printer lay the bottle
unit down as shown here for a couple of seconds then
stand it back up.
This sets the levels in the small side of the bottles
correctly (this is usually necessary due to movement
in shipping)
Make sure the tube support is fitted as shown. Note
the support is on top of the tubes with the double
sided tape upwards.
Put the cartridges into the printer and push them
firmly into place.
Take of the red tape and press the tube support into
position as shown. This is directly in front of the
center button of the printer.
Fit small tube clamp on the side of the printer as
shown.
Page 2