TM GEM TEC Manual gem tec™ Sales: 01332 855 085 Tehcnical: 01332 858 333
Index Page 1. R-wear Installation 2. R-wear Setup 3. Working with R-wear 4. Rhinestone Costs 5. Gem Tec Material (Application & Preparation) 6.
R-Wear Installation Place the R-wear software CD into the PC. You will be presented with the above window. Select RwearStudio INSTALL to begin the installation process. Click NEXT in the window above Select ‘I accept the terms in the license agreement’. Now click NEXT to continue. In the window above, if you prefer to install the software to a specific location click ‘Change’. Otherwise click NEXT to continue, the files with be saved to your C:\ drive as shown. Click NEXT to install..
R-Wear Setup Run R-wear, now click on File>Preferences. In the above window change the Currency to GBP. Engraving fonts are available to download from www.xpres.co.uk/techsupport Diagram 1 Now click on File>Output Device Setup. Set the Printer option to the relevant cutter, in this case the ‘Roland GX-24' as shown above. Click OK to confirm. Click on the Rhinestone button along the top property bar. The Rhinestone window docker will appear.
Working with R-Wear Diagram 1 Diagram 2 Diagram 3 Open a new page (File>New) and select your page size (250 x 250mm is generally sufficient). Using the Text Tool from the menu on the left hand side you can click on the workspace and type the relevant text as shown in diagram 1. You can then edit/format the text by selecting (clicking on) the text with the Select Tool (nodes will appear around the text once selected).
Working with R-Wear Once the cutter has been set up with the relevant material click Yes to start cutting the design. See overleaf on how to setup the materials ready for cutting. Now click File>Output>Print or select the Print icon from the top property bar - you will then see the window above. Tick the Print Stones & Cutting Lines option, you will now see the design appear as shown above (in blue). Now click Print. Rhinestone Costs After designing your transfer you can view cost details.
Gem Tec Material (Application & Preparation) To produce a Gem-Tec transfer you will require the following materials & accessories: ? Rhinestones (XP7500/1) ? Gem Tec Stencil Film (XP7504) ? Gem Tec Application Film (XP7505) ? Adhesive Film for Stencil (XP7507) Diagram 1 Diagram 2 ? Application Tray (XP4006) Using the Adhesive Film for Stencil cut a piece of material (using scissors/knife) slightly larger than the size of your transfer and remove the protective backing to reveal the sticky side of the fi
FAQ Q. Why is it difficult to get all of the Rhinestones into the template? A. The template holes need to be cut 0.2mm bigger than the size of the crystal for best results. - The wrong size Rhinestone may have been selected in R-wear - The diameter setting for the Rhinestone you are using should be set as shown in page 2 Q. The Stencil Film is not cutting correctly? A. We suggest to use the Flock Blade (red tip) at approximately 250g force. Q. When I click print the cutter does not respond? A.
