Manual
8
Doming using Xpres Cut Plus Doming using Versacamm
If using the Xpres Cut Plus (Ultragraphics) system, Xpres
Easy Dome can be used with the following transfer vinyls:
Self-Adhesive Doming Vinyl
XP4900 (A3) & XP4901 (A4)
To be used to create domed self-adhesive labels & signage
For best results print with the following quality settings:
Paper: Plain paper
Quality: Photo
Always place Silicon Sheet XP2028 below Self-Adhesive
Doming Vinyl before applying Easy Dome Resin in case of
overspill.
Dark Jet
XP3132 (A3) & XP3133 (A4)
To be used to create full colour domed transfer to be applied
to textiles (Cotton, Polyester & Nylon)
Application:
Position domed transfer over garment in the correct position
Apply at 175°C for 30 seconds
Turn garment inside out and press on to the back of the
transfer (inside of the garment) at 175°C for a further 30
seconds.
If using the Roland Versacamm or other Solvent / Eco
Solvent ink printers, Xpres Easy Dome can be used with the
following vinyls:
Tec Mark Digital Vinyl
XP2125 & XP2127
To create full colour domed labels & signage
Tec Mark Gloss Vinyl
XP2120 & XP2121
Gold & Silver vinyl to be used to create Domed Trophy Labels
and Centres at low cost
Easy Print
XP3030 / 3031 / 3033 / 3034
To create full colour domed transfers to be applied to textiles
(Cotton & Polyester)
Application to textiles:
Position domed transfer over garment in the correct position
Apply at 170°C for 30 seconds
Turn garment inside out and press on to the back of the
transfer (inside of the garment) at 170°C for a further 30
seconds.
Colour Cut
XP3001 XP3137
To create full colour domed transfers to be applied to textiles
(Cotton & Polyester)
Application to textiles:
Position domed transfer over garment in the correct position
Apply at 170°C for 30 seconds
Turn garment inside out and press on to the back of the
transfer (inside of the garment) at 170°C for a further 30
seconds.