Use and Care Manual

10 11
XTREMEDRY® Pro DIY Drying Tool Kit XTREMEDRY® Pro DIY Drying Tool Kit
DEHUMIDIFIER
Programmable Humidity
& Digital Display
CT
F/C
:
°C
%
RH
T
O
T
A
T
T
L
TIME
Temperature DisplayPower Control
Evaporator
Coil/
Environment
Temperature
Switch
Fahrenheit/Celsius
Scale Switch
Relative Humidity
Display
Total Running Time
Humidity Control
Fan Speed Manual Drainage
Step 1
Place dehumidier in the center of
the room with returning air in the
same direction as the air movers.
Step 2
Attach clear drain hose to unit and
attach the opposite end of the
hose in a drain like bathtub or sink.
Step 3
Attach power cord to unit and
plug into power outlet.
Step 4
Turn on dehumidier, press the power control button.
Step 3
Step 4
Step 2
Close the secondary intake when the environment temperature falls
under 68° F for better eciency.
Take out and ip the secondary intake cover along the short edge.
Reinstall the secondary intake cover. The secondary intake is now
covered.
When the unit is turned o, it will automatically start drainage for 75
seconds.
Please wait until this process completes.
Clean and wash the lters.
Use a damp cloth to wipe the surface
of the housing.
Do not clean the unit with
water directly.
IMPORTANT
MAINTENANCE
INSTRUCTIONS
Step 5
Place dehumidier in the center of the room with returning air in the
same direction as the air movers.
Step 6
Tap the humidity control button to adjust humidity level. You have a range
from 30% to 90%, if you want the machine to work, adjust humidity level
down to 30% and then press “-” you will see “CO” on control panel.
Step 7
When the machine is dehumidifying, the dehumidication light goes on.
If light is ashing, that means the dehumidication temporary pauses or
the humidity has reached the setting level. Please wait until the machine
completes the startup or until the humidity level rises up again.