Use and Care Manual

SET UP/OPERATION
BASIC OPERATION GUIDE
1. Press button to turn unit ON (*30 second delay
is normal if recently powered off)
2. Display shows Preferred Humidity Setting on Left
and Current Humidity on Right
3. Adjust and to set preferred humidity level
(90% to 26%)
4. Unit will run automatically, turning on and off to
maintain desired humidity level
5. To run continuously press to below 26% until
“CO” displays
6. Once job is complete, press button to turn the
unit off. The water pump will automatically purge for
40 seconds to drain.
 Always operate unit in an enclosed area, closing all
doors, windows and other pathways open to
external areas for maximum water removal
efficiency
 Keep traffic through drying area to a minimum
 Place the dehumidifier in the center of the room
away from walls and furnishings. (Fig. A)
 Uncoil entire drainage hose on rear of unit. Place
open end of hose into a drain, bucket, or outdoors.
Ensure drainage hose is not restricted or kinked.
DO NOT elevate hose higher than 15 ft. above unit.
(Fig B)
 Take care that water does not create a slip hazard. If
using a collection bucket check water level regularly.
READ ALL INSTRUCTIONS TO PREVENT SYSTEM DAMAGE
 For proper operation, DO NOT obstruct the air inlets/outlets, or drainage hose.
 WAIT 30 minutes after transporting unit to jobsite before switching ON to allow refrigerant system to
stabilize
 DO NOT switch the power OFF by disconnecting power cord
 WAIT at least three minutes after turning the power OFF to move unit.
FIG. A
FIG. B