XPOWER MANUFACTURE, INC. 220 Clary Ave., San Gabriel, CA 91776 PH: 626-285-3301 FAX: 626-285-3302 Email: info@xpower.ws Website: xpower.
Table of Contents INTRODUCTION ............................................................................................................................................................2 SAFETY INSTRUCTIONS.................................................................................................................................................3 ASSEMBLY & PARTS ............................................................................................................................................
INTRODUCTION The XPOWER XD-125 dehumidifier is a professional drying tool designed to maximize water extraction in a variety of temperature and humidity conditions. Perfect for water damage restoration jobs as well as other industrial applications; the XD-125 offers programmable humidity for optimal environment control.
SAFETY INSTRUCTIONS WARNING! - TO REDUCE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS OR PROPERTY: 1. Always operate the product from a power source of the same voltage, frequency and rating as indicated on the product identification plate. 2. Close supervision is necessary when any product is used by or near children, the elderly, or the infirm. Do not allow children to use the appliance as a toy. 3. Do not operate this product with a damaged power cord plug.
ASSEMBLY & PARTS 1. Your XD-125 Dehumidifier is fully assembled with the exception of the handle 2. Using a Phillips screwdriver, loosely attach each screw to unit. DO NOT TIGHTEN until all six screws have been fastened. (*You will experience some resistance as screws fit into housing). 3. Alternate diagonally between screws when tightening to ensure the best fit. 1. 2. 3. 4. Metal Handle Control Panel Semi-Pneumatic Wheels Water Hose Bracket 5. 6. 7. 8.
SET UP/OPERATION READ ALL INSTRUCTIONS TO PREVENT SYSTEM DAMAGE FIG. A For proper operation, DO NOT obstruct the air inlets/outlets, or drainage hose. WAIT 30 minutes after transporting unit to jobsite before switching ON to allow refrigerant system to stabilize DO NOT switch the power OFF by disconnecting power cord WAIT at least three minutes after turning the power OFF to move unit.
CONTROL PANEL 1. POWER (ON/OFF) 2. DISPLAY 3. UP AND DOWN CONTROLS 4. PURGE 5. TIME ON/OFF: Power button turns the unit ON or OFF 1. 2. DISPLAY: Left hand side indicates adjustable preferred humidity level, right side indicates current humidity. See #5 for reading time. 3. AND *By pressing continuously. : Set to adjust humidity ranging from 90% to 26%. key to below 26%, “CO” displays, confirming setting to run the machine 4. PURGE: Press to empty water from the pump reservoir.
CARE & MAINTENANCE - Cleaning the Air Filter Regular cleaning of filters is highly recommended. The performance of the dehumidifier will be greatly reduced if the filters become blocked. 1. Confirm the dehumidifier is turned OFF and the plug is disconnected from power outlet 2. Remove the filter as shown in the diagram. 3. Using a vacuum hose and nozzle, vacuum any debris from the filter. 4. Wash with warm water and a mild detergent and allow to air dry. 5. Once the filter is fully dried, re-install.
TROUBLESHOOTING WARNING! UNPLUG & POWER OFF BEFORE PERFORMING ANY MAINTENANCE PROBLEM CAUSE SOLUTION No power to appliance Check connection to power source. “Running” indicator light should flash green if unit is connected to a functional power source.
APDS-I (sold separately) Uses combined power of XPOWER Air Scrubber (X-3500) and Dehumidifier to remove moisture and contaminants from the air.
WARRANTY XPOWER 1 Year Limited Warranty covers the unit from defects in materials and craftsmanship. The Warranty covers normal use for a term of one year from the original date of purchase including parts, labor and one way shipping. Warranty does not cover signs of misuse including, but not limited to, a unit that has been dropped, subjected to water damage, tampered with, improper voltage use and unauthorized maintenance and repairs. The POWER CORD and FILTERS are not covered by the warranty.
