Use and Care Manual

English - 9
Fogging System Maintenance
Battery Maintenance
Cleaning the Solution Tank
• Turn the fogging volume control to the lowest setting.
• Fill the solution tank with cold water to half of maximum capacity, close the solution
tank and shake the machine a few times. Then open the solution tank and discard the
water inside. Repeat the steps above 2 times.
• Check if the solution tank is clean. If not, please repeat the steps above until tank is
fully cleaned.
• When not in use for a long time, please charge the battery until full before storage. It’s
recommended to charge the battery at least 1 time for every 3 months.
• DO NOT disassemble this machine personally. DO NOT disassemble the battery. If the
machine or battery malfunctions, refer to the Troubleshooting Guide.
Disposal of the Battery
• This product contains lithium ion batteries. Special disposal methods may be required
local disposal regulations.
Cleaning the Liquid Conduit and Fogging Outlet
• Turn the fogging volume control to the lowest setting.
• Fill the solution tank with cold water to half of maximum capacity and close the
solution tank.
• Turn on the machine and turn the fogging volume control to the highest setting.
Selection Suggestions of Cleaning Agent
• It’s recommended to use COLD WATER ONLY to clean the fogging system.
• You might follow the cleaning and disposal instructions of the liquids used for fogging if
applicable.
• WARNING: Filling these types of solution / liquid into the solution tank for cleaning,
may cause safety hazards, corrosive damages to the machine or blockage of the
fogging system.
(1) Strong acids, strong bases or other corrosive liquids
(2) Alcohol, or flammable or explosive liquids
(3) Oil, or other organic oils
(4) Liquids containing particles or sediments.
(5) Detergents
Fogging System Maintenance (Continued)
• Keep the machine working for 3 minutes. Turn the fogging volume control to the lowest
setting and turn off the machine.
• Open the solution tank and discard the water inside. Close the solution tank. Wipe the
water on the machine surface and the fogging outlet.