Operation Manual Duplex Grinding Machine 62852 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly. Updating the documentation If you have suggestions for improvement or have found any irregularities, please contact us.
The information contained in this document may be altered at any time without prior notice. Copying or spreading any part of this document in any way without prior written permission is prohibited. All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operation manual, including the diagrams and figures contained within.
Introduction Thank you for purchasing this quality product. To minimise the risk of injury we urge that our clients take some basic safety precautions when using this product. Please read this operation manual carefully and make sure you have understood its content. Always keep this operation manual safe and accessible. Bench grinders are used for deburring, grinding, and sharpening workpieces made of steel and steel alloys.
• Keep all safety information and instructions for the future. The term “power tool” used in the safety instructions relates to mains-operated electric tools (with a mains cable) and batteryoperated electric tools (without a cable). Work area safety • • • Always keep your working area clean and well-lit. Cluttered or insufficiently lit working areas increase the risk of accident. Do not operate the device in explosive environments or near flammable substances, liquids, gases, or dusts.
• • • Maintain power tools with care. Check if moving parts are working properly and are not jamming and if parts are broken or damaged so that the function of the power tool is impaired. Have damaged parts repaired before using the device. The cause of many accidents involving power tools is poor maintenance. Keep cutting tools sharp and clean. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to guide. Use the power tool, accessories, tool bits etc.
Important note! • • If the motor is overloaded, it switches itself off. After a cooling-down period (different in time), the motor can be switched on again. Hold the workpieces to be processed with a tool holder (e.g., pliers) to avoid injuries. Main components № Name № Name 1 Protective screen 5 Workpiece support 2 Abrasive wheel cover 6 Abrasive wheel 3 Hole for work bench installation 7 Spark protection cover 4 On/off switch 8 Abrasive wheel https://www.XPOtool.
Assembly https://www.XPOtool.
https://www.XPOtool.
https://www.XPOtool.
Levelling https://www.XPOtool.
Changing grinding wheel https://www.XPOtool.
Operation https://www.XPOtool.
Maintenance Attention! Make sure the device has been turned off and disconnect it from its power source before performing any kind of maintenance. Warning! Do not use this device if it or any of its parts are worn-out or damaged. • • • • • • Repairs and in-depths maintenance work may only be performed my qualified personnel. Always keep the machine and especially its ventilation slots clean and ensure they are unobstructed. The sawdust ejection and/or dust exhaust should be cleaned at regular intervals.
Disposal regulations EU guidelines regarding the disposal of scrap electric appliances (WEEE, 2012/19/EU) were implemented in the law related to electrical and electronic equipment and appliances. All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the domestic waste.
