Windows 10

Using the Fingerprint Reader

You can use the fingerprint reader to log into the Tablet by scanning your fingerprint instead of

entering a password. This feature provides an additional level of security for the tablet.

Note: You need to have a password for logging into your system before setup.

Creating a PIN

To use the fingerprint reader, you need to create a PIN.

1. Swipe left from the right edge of the screen and tap All Settings.

2. Tap Accounts.

3. In the left pane, tap Sign-in options.

4. In the right pane of the Sign-in options, under Pin, tap Add.

5. Enter your PIN and tap OK. (The PIN is user created.)

Setting Up the Fingerprint Reader

After you have a PIN, the Windows Hello section of the Sign-in options is enabled.

1. In the Windows Hello section under Fingerprint, tap Set up.

2. Tap Get Started.

3. Enter you PIN.

4. Scan your finger on the fingerprint reader a few times.

The message provides instructions.

5. Tap Close.

Next time you log in, you can use your PIN or use your finger on the reader.

Fingerprint Reader Tips

 Be consistent. Hold your finger and scan at the same angle each time.

 The scanner is bidirectional. You can move your finger from right to left or left to right.

 Wait for prompt before you swipe.

 Swiping too quickly or too slowly can make a capture unsuccessful.

 When scanning, press hard enough to fully contact the sensor.

 Rub your fingers together to stimulate the natural skin oils so your fingerprint is easier to

detect.

Using the SlateMate Module (Optional)

The XSLATE R12-Series SlateMate® option is factory-installed module consisting of a barcode scanner

(BCS), high-frequency RFID ready (HF RFID), and a serial port. Two configurations are available.

 3-in-1 module (BCS, HF RFID Reader, and Serial Port)

 2-in-1 module (HF RFID Reader, and Serial Port)