User manual

Maintenance and Troubleshooting
7. Allow at least 10 to 30 minutes (depending on ambient temperature and humidity) for the alcohol to air
dry before applying power to cradle.
If the temperature is low and humidity is high, longer drying time is required. Warm temperature and low
humidity requires less drying time.
CAUTION: After cleaning the cradle connectors with bleach-based chemicals, follow the
Cleaning Cradle Connectors instructions to remove bleach from the connectors.
Power Connector
Use only the recommended materials for cleaning the power connector.
1. Remove the main battery from the tablet.
2. Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.
3. Use the cotton tipped applicator dipped in alcohol to remove any grease and dirt near the connector
area.
4. Repeat steps 2 and 3 a total of three times.
5. Spray compressed air on the connector area by pointing the tube/nozzle about ½ inch away from the
surface.
Do not point nozzle at yourself and others, ensure the nozzle or tube is pointed away from your face.
6. Inspect the area for any grease or dirt, repeat if required.
Fingerprint Reader
Under normal circumstances, you should clean the fingerprint reader once a month, or whenever
necessary.
To clean the fingerprint reader, gently rub the sensor surface with the cloth that is included with the tablet
or any microfiber cloth.
You can use a small amount of alcohol or warm soapy water from time to time to clean the reader surface.
Dry it off after cleaning.
CAUTION: Do not use bleach, solvents, or abrasives to clean the reader.
Caring for the Display
Follow these suggestions to keep your display clean.
• Clean fingerprints and smudges from the display surface by wiping it with a microfiber cloth.
• If liquid is spilled on the display, wipe it up immediately with a soft microfiber cloth.
• Use only the L10ax pen or your finger to write on the display. Any other object could damage the
display surface.
• Protect the display surface from unnecessary contact by using a carry case when transporting the
tablet.
• Avoid exposing the display to direct sunlight for long periods of time.
• Every L10ax ships from factory with a protective display film.
63