User manual
Table Of Contents
- Contents
- About This Guide
- Getting Started
- Using the Device
- Software
- Data Capture
- Wireless
- Accessories
- Maintenance and Troubleshooting
- Specifications
Wireless
Enabling NFC
NFC is disabled by default. Before using NFC, you must enable it in the BIOS and then in Windows.
1. Enter the BIOS setup.
See Enter the BIOS on page 39.
2. From the BIOS setup screen, select the Advanced tab.
3. Select NFC Controller > Enabled.
4. Select the Save & Exit tab.
5. Select Exit Saving Changes > Yes.
6. After Windows loads, go to Settings > Network & Internet > Airplane mode. Under Wireless devices,
select the NFC slider to turn it on.
Reading NFC Cards
The tablet supports reading NFC cards.
With an NFC enabled application open, bring the NFC card toward the antenna (1). Depending upon the
application, an audio or visual indication indicates successful reading of the card.
53