User manual

Getting Started
• Finger and Glove
• Finger and Passive Stylus (default)
Figure 3Short Active Digitizer Pen
Figure 4Long Active Digitizer Pen
Optional Setup Tasks
This sectionexplains how to attach the pen tether and how to connect the tablet to an external monitor.
Attaching the Pen Tether
The pen comes with a tether so that you can attach it to your tablet to avoid misplacing it.
1. Slip one end of the tether through the hole at the end of the pen, and pull the pen through the loop until
it is tight.
2. Slip the other end of the tether through the attach point on the tablet, then pull the pen through the
loop until it is tight.
Connecting the Tablet to an External Monitor
There is no dedicated port for an external monitor on the tablet. The tablet has a USB Type-C connector
which includes a Display Port output capability. You need a dongle that supports USB Type-C DisplayPort
and converts it to the port necessary to attach the external monitor, which can have one or more of the
following ports: HDMI, DVI, DisplayPort, or VGA.
For instance, to connect a monitor with an HDMI port to your tablet, you need a USB Type-C DisplayPort to
HDMI output dongle.
NOTE: Some dongles use USB to Video conversion and these use software to enable the
external display over USB interface. Care must be taken to ensure the USB Type-C dongle
specifically supports USB Type-C Display Port input. Look for a dongle that states it is plug-n-play
and that no software or drivers are required.
Back of Battery Charge Indicators
You can check the charge of a battery when it is out of the tablet by pressing the battery check button on
the rear.
IMPORTANT: If you remove the battery while the tablet is running, you only have one minute to
replace it to keep the tablet running. If you need to remove it for a longer period, be sure to save
your files. Then, shut down or plug into a power source.
22