Quick Start

Table Of Contents

L10ax Quick Start Guide

5. Press and release Power (1) in the center of the right side of the tablet to turn it on.

6. Keep the tablet on AC power until the battery is fully charged. However, you don’t have to wait until the

tablet is fully charged to turn it on. The L10ax charges while you use it.

Optional Setup Tasks

This sectionexplains how to attach the pen tether and how to connect the tablet to an external monitor.

Attaching the Pen Tether

The pen comes with a tether so that you can attach it to your tablet to avoid misplacing it.

1. Slip one end of the tether through the hole at the end of the pen, and pull the pen through the loop until

it is tight.

2. Slip the other end of the tether through the attach point on the tablet, then pull the pen through the

loop until it is tight.

Connecting the Tablet to an External Monitor

There is no dedicated port for an external monitor on the tablet. The tablet has a USB Type-C connector

which includes a Display Port output capability. You need a dongle that supports USB Type-C DisplayPort

and converts it to the port necessary to attach the external monitor, which can have one or more of the

following ports: HDMI, DVI, DisplayPort, or VGA.

For instance, to connect a monitor with an HDMI port to your tablet, you need a USB Type-C DisplayPort to

HDMI output dongle.

NOTE: Some dongles use USB to Video conversion and these use software to enable the

external display over USB interface. Care must be taken to ensure the USB Type-C dongle

specifically supports USB Type-C Display Port input. Look for a dongle that states it is plug-n-play

and that no software or drivers are required.

Back of Battery Charge Indicators

You can check the charge of a battery when it is out of the tablet by pressing the battery check button on

the rear.

IMPORTANT: If you remove the battery while the tablet is running, you only have one minute to

replace it to keep the tablet running. If you need to remove it for a longer period, be sure to save

your files. Then, shut down or plug into a power source.

If you have a battery out of the tablet, you can check the charge by looking at the rear and pressing the

button to the left of the lights to view the charge level.