User manual
Table Of Contents
- Copyright
- Terms of Use
- Revision History
- Table of Contents
- About this Guide
- Getting Started
- Using the Device
- Applications
- Settings
- Wireless
- Data Capture
- Operational Modes
- Scanning Considerations
- Integrated Barcode Scanner (XPAD Only)
- RS507/RS507X Hands-Free Imager
- RS5100 Ring Scanner
- RS6000 Bluetooth Ring Scanner
- DS3608 Digital Scanner
- Scanning with the Barcode Scanner (XPAD Only)
- Scanning with RS507/RS507X Hands-Free Imager
- Scanning with RS5100 Ring Scanner
- Scanning with RS6000 Bluetooth Ring Scanner
- Scanning with the DS3608 Scanner
- Pairing the RS507/RS5100/RS6000 Ring Scanner
- Pairing a Bluetooth Scanner
- Connecting a USB Scanner
- DataWedge
- Accessories
- Application Deployment
- Maintenance and Troubleshooting
- Specifications
- Index
Data Capture
95
Figure 35 RS5100/RS6000 Bluetooth HID Barcode
5. Remove the battery from the ring scanner.
6. Re-install the battery into the ring scanner.
7. Swipe down from the Status bar to open the Quick Access panel and then touch .
8. Touch Bluetooth.
9. Touch Pair new device. The device begins searching for discoverable Bluetooth devices in the area
and displays them under Available devices.
10. Scroll through the list and select the ring scanner.
The device connects to the ring scanner and Connected appears below the device name. The
Bluetooth device is added to the Paired devices list and a trusted (“paired”) connection is established.
A notification appears on Notification panel and the icon appears in the Status bar.
Pairing a Bluetooth Scanner
Connect the scanner to the device using one of the following methods:
• Simple Serial Interface (SSI) mode
• Bluetooth Human Interface Device (HID) mode.
Pairing Using Simple Serial Interface
To pair the Bluetooth scanner with the device using SSI:
1. Ensure that the two devices are within 10 meters (32.8 feet) of one another.
2. Install the battery into the scanner.
3. On the device swipe up from the bottom of the Home screen and touch .
4. Using the scanner, scan the barcode on the screen.
The scanner emits a high/low/high/low beeps. The Scan LED flashes green indicating that the scanner
is attempting to establish connection with the device. When connection is established, the Scan LED
turns off and the scanner emits one string of low/high beeps.
5. On the device touch Home.
Pairing Using Bluetooth Human Interface Device
To pair the Bluetooth scanner with the device using HID:
1. Remove the battery from the scanner.
2. Replace the battery.