User manual

Data Capture
94
2.
Using the ring scanner, scan the barcode on the screen.
The ring scanner emits a string of high/low/high/low beeps. The Scan LED flashes green indicating that
the ring scanner is attempting to establish connection with the device. When connection is established,
the Scan LED turns off and the ring scanner emits one string of low/high beeps.
A notification appears on the Notification panel and the icon appears in the Status bar.
Pairing Using Bluetooth Human Interface Device
To pair the ring scanner with the device using Human Interface Device (HID):
1. Ensure that Bluetooth is enabled on both devices.
2. Ensure that the Bluetooth device to discover is in discoverable mode.
3. Ensure that the two devices are within 10 meters (32.8 feet) of one another.
4. Place the ring scanner in HID mode. If the ring scanner is already in HID mode, skip to step 5.
a. Remove the battery from the ring scanner.
b. Press and hold the Restore key.
c. Install the battery onto the ring scanner.
d. Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash
green.
e. Scan the barcode below to place the ring scanner in HID mode.
Figure 34 RS507/RS507X Bluetooth HID Barcode