User manual
Table Of Contents
- Copyright
- Terms of Use
- Revision History
- Table of Contents
- About this Guide
- Getting Started
- Using the Device
- Applications
- Settings
- Wireless
- Data Capture
- Operational Modes
- Scanning Considerations
- Integrated Barcode Scanner (XPAD Only)
- RS507/RS507X Hands-Free Imager
- RS5100 Ring Scanner
- RS6000 Bluetooth Ring Scanner
- DS3608 Digital Scanner
- Scanning with the Barcode Scanner (XPAD Only)
- Scanning with RS507/RS507X Hands-Free Imager
- Scanning with RS5100 Ring Scanner
- Scanning with RS6000 Bluetooth Ring Scanner
- Scanning with the DS3608 Scanner
- Pairing the RS507/RS5100/RS6000 Ring Scanner
- Pairing a Bluetooth Scanner
- Connecting a USB Scanner
- DataWedge
- Accessories
- Application Deployment
- Maintenance and Troubleshooting
- Specifications
- Index
Data Capture
92
4.
Press and hold the trigger.
The red laser aiming pattern turns on to assist in aiming. Ensure the barcode is within the area formed
by the cross-hairs in the aiming pattern. The aiming dot increases visibility in bright lighting conditions.
The RS6000 LEDs light green and a beep sounds to indicate the barcode was decoded successfully.
When the RS6000 is in Pick List mode, the RS6000 does not decode the barcode until the center of the
crosshair touches the barcode.
Figure 30 RS6000 Aiming Pattern
Figure 31 RS6000 Pick List Mode with Multiple Barcodes in Aiming Pattern
5. The captured data appears in the text field.
Scanning with the DS3608 Scanner
To scan:
1. Connect the USB scanner to the device or pair the Bluetooth scanner with the device. For more
information, see Connecting a USB Scanner on page 96 for the USB scanners.
2. Ensure that an app is open on the device and a text field is in focus (text cursor in text field).
3. Point the scanner at a barcode.