User manual
Table Of Contents
- Copyright
- Terms of Use
- Revision History
- Table of Contents
- About this Guide
- Getting Started
- Using the Device
- Applications
- Settings
- Wireless
- Data Capture
- Operational Modes
- Scanning Considerations
- Integrated Barcode Scanner (XPAD Only)
- RS507/RS507X Hands-Free Imager
- RS5100 Ring Scanner
- RS6000 Bluetooth Ring Scanner
- DS3608 Digital Scanner
- Scanning with the Barcode Scanner (XPAD Only)
- Scanning with RS507/RS507X Hands-Free Imager
- Scanning with RS5100 Ring Scanner
- Scanning with RS6000 Bluetooth Ring Scanner
- Scanning with the DS3608 Scanner
- Pairing the RS507/RS5100/RS6000 Ring Scanner
- Pairing a Bluetooth Scanner
- Connecting a USB Scanner
- DataWedge
- Accessories
- Application Deployment
- Maintenance and Troubleshooting
- Specifications
- Index
Data Capture
89
Scanning with RS507/RS507X Hands-Free Imager
To read a barcode, a scan-enabled app is required. The device contains the DataWedge app that allows
you to enable the scanner to decode barcode data and display the barcode content.
To scan with the RS507/RS507X:
1. Pair the RS507/RS507X with the device. Pairing a Bluetooth Scanner on page 95
for more information.
2. Ensure that an app is open on the device and a text field is in focus (text cursor in text field).
3. Point the RS507/RS507X at a barcode.
4. Press and hold the trigger.
The red laser aiming pattern turns on to assist in aiming. Ensure the barcode is within the area formed
by the cross-hairs in the aiming pattern. The aiming dot increases visibility in bright lighting conditions.
The RS507/RS507X LEDs light green and a beep sounds to indicate the barcode was decoded
successfully. When the RS507/RS507X is in Pick List mode, the RS507/RS507X does not decode the
barcode until the center of the crosshair touches the barcode.
Figure 26 RS507/RS507X Aiming Pattern