User manual
Table Of Contents
- Copyright
- Terms of Use
- Revision History
- Table of Contents
- About this Guide
- Getting Started
- Using the Device
- Applications
- Settings
- Wireless
- Data Capture
- Operational Modes
- Scanning Considerations
- Integrated Barcode Scanner (XPAD Only)
- RS507/RS507X Hands-Free Imager
- RS5100 Ring Scanner
- RS6000 Bluetooth Ring Scanner
- DS3608 Digital Scanner
- Scanning with the Barcode Scanner (XPAD Only)
- Scanning with RS507/RS507X Hands-Free Imager
- Scanning with RS5100 Ring Scanner
- Scanning with RS6000 Bluetooth Ring Scanner
- Scanning with the DS3608 Scanner
- Pairing the RS507/RS5100/RS6000 Ring Scanner
- Pairing a Bluetooth Scanner
- Connecting a USB Scanner
- DataWedge
- Accessories
- Application Deployment
- Maintenance and Troubleshooting
- Specifications
- Index
Getting Started
27
3.
Insert your finger under the pull-out battery tab and pull to remove the battery from the battery
compartment.
Replacing the Battery
1. Place the tabbed end of the battery into the battery compartment.
2. Press the battery down until it snaps into place.
Hot Swapping the Battery
Replacing a battery while the tablet is on is called hot swapping. You can hot swap a battery only if you
have a second, charged battery to replace it with.
IMPORTANT: You have approximately one minute to hot swap the battery. If you have not replaced the
battery within one minute, the tablet goes into Sleep mode.
1. Remove the battery.
2. Insert the new battery.
While hot swapping the battery, notice the following behaviors:
• The tablet display gets dimmer. When the charged battery is in the tablet, the display brightens again.
• The battery status LED turns blue when the system is on and no main battery is present. When you put
a charged battery in the tablet, the LED lights turn green again.
• The power button is disabled. (The power button is disabled at any time the tablet has no battery and is
not running on AC power through the power adapter.)
1 Sliding battery latch
2 Pull-out battery tab
21