User manual
Table Of Contents
- Copyright
- Terms of Use
- Revision History
- Table of Contents
- About this Guide
- Getting Started
- Using the Device
- Applications
- Settings
- Wireless
- Data Capture
- Operational Modes
- Scanning Considerations
- Integrated Barcode Scanner (XPAD Only)
- RS507/RS507X Hands-Free Imager
- RS5100 Ring Scanner
- RS6000 Bluetooth Ring Scanner
- DS3608 Digital Scanner
- Scanning with the Barcode Scanner (XPAD Only)
- Scanning with RS507/RS507X Hands-Free Imager
- Scanning with RS5100 Ring Scanner
- Scanning with RS6000 Bluetooth Ring Scanner
- Scanning with the DS3608 Scanner
- Pairing the RS507/RS5100/RS6000 Ring Scanner
- Pairing a Bluetooth Scanner
- Connecting a USB Scanner
- DataWedge
- Accessories
- Application Deployment
- Maintenance and Troubleshooting
- Specifications
- Index
Getting Started
25
Optional Setup Tasks
Attaching the Pen Tether
The pen comes with a tether so that you can attach it to your tablet to avoid misplacing it.
1. Slip one end of the tether through the hole at the end of the pen, and pull the pen through the loop until
it is tight.
2. Slip the other end of the tether through the attach point on the tablet, then pull the pen through the loop
until it is tight.
Connecting the Tablet to an External Monitor
There is no dedicated port for an external monitor on the L10 tablet. The tablet has a USB Type-C
connector which includes a DisplayPort output capability. You need a dongle that supports USB Type-C
DisplayPort and converts it to the port necessary to attach the external monitor, which can have one or
more of the following ports: HDMI, DVI, DisplayPort, or VGA.
For instance, to connect a monitor with an HDMI port to your tablet, you need a USB Type-C DisplayPort to
HDMI output dongle.
NOTE: Some dongles use USB to Video conversion and these use software to enable the external display
over USB interface. Care must be taken to ensure the USB Type-C dongle specifically supports USB
Type-C DisplayPort input. Look for a dongle that states it is plug-n-play and that no software or drivers are
required.
Back of Battery Charge Indicators
You can check the charge of a battery when it is out of the tablet by pressing the battery check button on
the back side.
IMPORTANT: If you remove the battery while the tablet is running, you only have one minute to replace it
to keep the tablet running. If you need to remove it for a longer period, be sure to save your files. Then shut
down or plug in to a power source.