User manual
Table Of Contents
- Copyright
- Terms of Use
- Revision History
- Table of Contents
- About this Guide
- Getting Started
- Using the Device
- Applications
- Settings
- Wireless
- Data Capture
- Operational Modes
- Scanning Considerations
- Integrated Barcode Scanner (XPAD Only)
- RS507/RS507X Hands-Free Imager
- RS5100 Ring Scanner
- RS6000 Bluetooth Ring Scanner
- DS3608 Digital Scanner
- Scanning with the Barcode Scanner (XPAD Only)
- Scanning with RS507/RS507X Hands-Free Imager
- Scanning with RS5100 Ring Scanner
- Scanning with RS6000 Bluetooth Ring Scanner
- Scanning with the DS3608 Scanner
- Pairing the RS507/RS5100/RS6000 Ring Scanner
- Pairing a Bluetooth Scanner
- Connecting a USB Scanner
- DataWedge
- Accessories
- Application Deployment
- Maintenance and Troubleshooting
- Specifications
- Index
Maintenance and Troubleshooting
128
Troubleshooting
Restarting the L10
There are two reset features on the device: Restart and a hard reset switch.
Soft Reset
Reboot the device if applications stop responding.
1. Press the Power button until a small menu appears.
2. Touch Restart.
The device restarts.
Hard Reset
If the device is not responsive, use the reset switch on the front of the tablet. This switch turns the power
off immediately.
CAUTION: Performing a hard reset with a microSD card installed in the device can cause damage or data
corruption to the memory card, causing all data on the microSD card to be lost.
1. If a microSD card installed in the device, remove it before you use the reset switch. To access the
microSD card, open the port cover on the left side of the tablet and remove the microSD card. This
removal will preserve the data on the memory card.
2. Use the stylus tip on the tablet pen and insert it into the reset hole to press the recessed button until the
tablet shuts down. (You can also use a paper clip and unbend it to form a pin.)
Figure 36 Reset Switch on Front of Tablet
1 Hard Reset Button
1