User manual

Table Of Contents
Maintenance and Troubleshooting
126
Cleaning the Cradle Connector
Use this procedure to clean the connectors on a cradle:
1. Remove power from the cradle.
2. Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.
3. Rub the cotton portion of the cotton tipped applicator along the pins of the connector. Slowly move the
applicator back-and-forth from one side of the connector to the other. Do not let
leave any cotton
residue on the connector.
4. All sides of the connector should also be rubbed with the cotton tipped applicator.
5. Spray compressed air in the connector area by pointing the tube/nozzle about ½ inch away from the
surface.
CAUTION: Do not point nozzle at yourself and others, ensure the nozzle or tube is pointed away from your
face.
6. Ensure that there is no lint left by the cotton tipped applicator.
7. If grease and other dirt can be found on other areas of the cradle, use lint free cloth and alcohol to
remove.
8. Allow at least 10 to 30 minutes (depending on ambient temperature and humidity) for the alcohol to air
dry before applying power to cradle.
9. If the temperature is low and humidity is high, longer drying time is required. Warm temperature and dry
humidity requires less drying time.
Caring for the Display
Follow these suggestions to keep your display clean:
Clean fingerprints and smudges from the display surface by wiping it with a microfiber cloth.
If liquid is spilled on the display, wipe it up immediately with a soft microfiber cloth.
Use only the L10 pen or your finger to write on the display. Any other object could damage the display
surface.
Protect the display surface from unnecessary contact by using a carry case when transporting the
tablet.
Avoid exposing the display to direct sunlight for long periods of time.
Every L10 ships from factory with a protective display film.
There are a range of products specifically for your L10 tablet. Refer to the accessories online,
zebra.com/support
.
Caring for the Pen
If you use an active (digitizer) pen with your tablet:
Store the active (digitizer) pen in the pen holder when not in use.
Avoid storing the pen vertically on its tip. It can damage the pen-to-digitizer function.
Keep the pen away from any liquid, because the pen contains electronic components that can be
damaged when wet.