Integrator Guide for Windows 10

Accessories 2 - 9
Figure 2-9 Communication and Charging Cradle - Setup
Installing the Insert
The insert must be installed onto the cradle when docking an ET5X without a protective boot.
1. Align the insert over the pins.
Figure 2-10 Align Insert with Cradle
2. Press the insert down until it seats flush in the cradle.
Charging the ET5X
To charge the ET5X in the Communication and Charging Cradle:
1. Open the bottom access door and hold it to the back of the tablet.
2. Align the ET5X with the alignment pins on the cradle.
3. Insert the ET5X into the cradle. Note that the Communication and Charging Cradles contains a locking
mechanism that locks the ET5X to the cradle.