Integrator Guide for Windows 10
Manuals
Brands
Xplore Zebra Manuals
Graphics Tablets
ET5x
11
12
13
14
15
16
17
18
19
20
Table Of Contents
Revision History
Table of Contents
About This Guide
Introduction
Documentation Set
Configurations
Chapter Descriptions
Notational Conventions
Related Documents and Software
Service Information
Chapter 1 Getting Started
Introduction
Unpacking
Getting Started
Installing a micro SIM Card (ET55 Only)
Charging the ET5X
Restarting the ET5X
Performing a Cold Boot
Chapter 2 Accessories
Introduction
Charge Only Cradle
Installing the Insert
Charging the ET5X
Communication and Charging Cradle
Installing the Insert
Charging the ET5X
Rugged Communication and Charging Cradle
Charging the ET5X
4-Slot Charge Only Cradle
Insert Installation
Guide Installation
Battery Charger Installation
Power Setup
Insert Tablet into Slot
ET5X without Rugged Frame
ET5X with Rugged Frame
Charging th Battery
4-Slot Battery Charger
Rugged Frame
Expansion Back
Installation
Programming the SE4710/SE4750 Expansion Backs
HID Keyboard Emulation Bar Code
Replacement Hand Strap
Attaching the Stylus to the Expansion Back
Removal
Chapter 3 Software
Introduction
Factory Reset
System Updates
Creating Installation USB Thumb Drive
Setup Using Communication Dock
Setup Using a USB Hub
Updating the Operating System
Checking Versions
Check ULPMC Version
Check BIOS Version
Check Operating System Version
Data Capture Application Development
Application Installation
Install from the Internet
Windows Store
Chapter 4 Maintenance and Troubleshooting
Introduction
Maintaining the ET5X
Battery Safety Guidelines
Cleaning
Materials Required
Cleaning the ET5X
Housing
Display
Power Connector
Cleaning Cradle Connectors
Cleaning Expansion Back Connectors
Cleaning Frequency
Troubleshooting
ET5X
Charge Only Cradle
Communication and Charging Cradles
Expansion Backs
Appendix A Specifications
Technical Specifications
ET5X
SE4710 Expansion Back Decode Range
SE4750 Expansion Back Decode Range
SE4750 SR Decode Ranges
SE4750 MR Decode Ranges
Accessory Specifications
Charge Only Cradle
Communication and Charging Cradle
Rugged Communication and Charging Cradle
Expansion Backs
Index
1 - 6
ET5X Integrator Guide for Windows 10
3.
The device restarts.
Performing a Cold Boot
If the ET5X does not respond to any input, perform a cold boot:
1.
Press and hold the power button for at least 10 seconds. The ET5X shuts down.
2.
Press the Power button to turn on the device.
1
...
...
18
19
20
21
22
...
...
96
