U.M. Windows 10
Table Of Contents
- Copyright
- Terms of Use
- Revision History
- About This Guide
- Getting Started
- Introduction
- Unpacking
- Features
- Getting Started
- Replacing the SIM Card
- Replacing the microSD Card
- Using the Tablet
- Wireless
- Data Capture
- Expansion Back
- RS507/RS507X Hands-Free Imager
- RS6000 Bluetooth Ring Scanner
- DS3678 Digital Scanner
- Imaging
- Scanning Considerations
- Scanning with the SE4710 Expansion Back
- Scanning with SE4750 Expansion Back
- Scanning with RS507/RS507X Hands-Free Imager
- Scanning with RS6000 Bluetooth Ring Scanner
- Scanning with the DS3608 USB Scanner or DS3678 Bluetooth Scanner
- Pairing Bluetooth Scanners
- Connecting a USB Scanner
- Accessories
- Maintenance and Troubleshooting
- Specifications
- Index
Data Capture
57
Figure 45 Add Bluetooth Device
7. When the scanner appears, touch the ID. After a few minutes a notification appears that the devices are
ready.
RS507/RS507X or RS6000 in SPP Mode
To pair the RS507/RS507X or RS6000 scanner with the tablet using or Serial Port Profile (SPP) mode:
1. Place the scanner in SPP mode using steps “a” through “e” below. If the scanner is already in SPP mode,
skip to step 2.
a. Remove the battery from the scanner.
b. Press and hold the Restore key.
c. Install the battery onto the scanner.
d. Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash
green.
e. Scan the appropriate barcode below to place the scanner in SPP mode.
Figure 46 RS507 Bluetooth SPP Barcode
Figure 47 RS6000 Bluetooth SPP Barcode