Integrator Guide for Windows

Accessories 2 - 15
Figure 2-21 Secure Screws
4. Using a T6 Torx screwdriver, secure expansion back to device using four screws. Torque to 14 n-cm.
Programming the SE4710/SE4750 Expansion Backs
Program the imager in the Expansion Backs using the Zebra 123Scan
2
application. Download the Zebra 123Scan
2
application from the Support Central web site.
HID Keyboard Emulation Bar Code
By default, the Expansion Back imager is set to HID mode. If the scanner is not working scan the bar code below to
place the scanner in HID mode.
Figure 2-22 HID Keyboard Emulation Bar Code
Replacement Hand Strap
To replace the hand strap:
1. If the Power Pack is installed, remove the Power Pack.
2. Rotate the disk so that the strap end without the eyelet is aligned with the Power Pack opening.
3. Open both ends of the hand strap.
Screws (4)
NOTE The Expansion Backs use decoder PL3307.