User manual

Data Capture
3. Press and hold one of the scan buttons.
The aiming dot with illumination turns on to assist in aiming.
NOTE: When the device is in Pick List Mode, the device does not decode the barcode until
the center of the aiming dot touches the barcode.
4. Ensure the barcode is within the area formed by the aiming pattern.The aiming dot is used for
increased visibility in bright lighting conditions.
The Data Capture LED lights green and a beep sounds, by default, to indicate the barcode was
decoded successfully.
Scanning with the Camera
Use theinternal camera to capture barcode data.
NOTE: To read a barcode, a scan-enabled app is required.The device contains the DataWedge
app that allows the user to enable the scanner to decode barcode data and display the barcode
content.
NOTE: The integrated camera is intended for light-duty barcode scanning. For heavy-duty
scanning, 100 or more scans per day, use the 2D imager.
When capturing barcode data in poor lighting, turn on Illumination mode in the DataWedge application.
To scan with the internal camera:
1. Launch a scanning application.
2. Point the camera window at a barcode.
3. Press and hold thescan button. By default, a preview window appears on the screen.
4. Move the device until the barcode is visible on the screen.
5. If Picklist mode is enabled, move the device until the barcode is centered under the aiming dot on the
screen.
The Decode LED lights green, a beep sounds and the device vibrates, by default, to indicate the barcode is
decoded successfully.
61