User manual
Table Of Contents
- Contents
- About this Guide
- Getting Started
- Using the Device
- Settings
- Applications
- Data Capture
- Imaging
- Scanning Considerations
- Scanning with an Internal Scanner
- Scanning with the Camera
- Scanning with the RS507/RS507X Hands-Free Imager
- Scanning with the RS5100 Ring Scanner
- Scanning with the RS6000 Bluetooth Ring Scanner
- Scanning with the DS2278 Digital Scanner
- Scanning with the DS3678 Bluetooth Scanner
- Scanning with the DS8178 Digital Scanner
- Scanning with the LI3678 Linear Imager
- DataWedge
- Supported Decoders
- Camera Supported Decoders
- SE4100 Internal Imager Supported Decoders
- SE4710 Internal Imager Supported Decoders
- SE4720 Internal Imager Supported Decoders
- RS507/RS507x Supported Decoders
- RS5100 Supported Decoders
- RS6000 Supported Decoders
- DS2278 Supported Decoders
- DS3678 Supported Decoders
- DS8178 Supported Decoders
- LI3678 Supported Decoders
- Wireless
- Accessories
- Application Deployment
- Maintenance and Troubleshooting
- Technical Specifications
Getting Started
3. Using your fingernail, slide and hold the battery lock switch in the unlock position (1).
4. While the switch is in the unlock position, lift the battery from the notched area(2), rotate the battery
up and then remove it from the battery well (3).
2
3
1
5. After removing the battery from the tablet, release the battery lock switch.
6. If replacing the nano SIM card,remove the existing card.
a) Push in the installed SIM card and release.
b) The card ejects slightly so that you can remove it.
c) Remove the SIM card from the card slot. The card should easily slide out. If not, the SIM card was
not ejected correctly. Repeat step A.
7. Insert the nano SIM card with the contacts facing up.
8. Push the SIM card in and ensure that it locks into place.
19