User manual
Table Of Contents
- Contents
- About this Guide
- Getting Started
- Using the Device
- Settings
- Applications
- Data Capture
- Imaging
- Scanning Considerations
- Scanning with an Internal Scanner
- Scanning with the Camera
- Scanning with the RS507/RS507X Hands-Free Imager
- Scanning with the RS5100 Ring Scanner
- Scanning with the RS6000 Bluetooth Ring Scanner
- Scanning with the DS2278 Digital Scanner
- Scanning with the DS3678 Bluetooth Scanner
- Scanning with the DS8178 Digital Scanner
- Scanning with the LI3678 Linear Imager
- DataWedge
- Supported Decoders
- Camera Supported Decoders
- SE4100 Internal Imager Supported Decoders
- SE4710 Internal Imager Supported Decoders
- SE4720 Internal Imager Supported Decoders
- RS507/RS507x Supported Decoders
- RS5100 Supported Decoders
- RS6000 Supported Decoders
- DS2278 Supported Decoders
- DS3678 Supported Decoders
- DS8178 Supported Decoders
- LI3678 Supported Decoders
- Wireless
- Accessories
- Application Deployment
- Maintenance and Troubleshooting
- Technical Specifications
Maintenance and Troubleshooting
Symptom Possible Cause Solution
Power Pack is faulty. Verify that other Power Pack charge properly. If so,
replace the faulty Power Pack.
The Power Pack is not
fully seated in the charger.
Remove and re-insert the Power Pack into the
charger, ensuring it is firmly seated.
Ambient temperature of
the charger is too warm or
too cold.
Move the charger to an area where the ambient
temperature is between 0°C and 40°C (32°F and
104°F).
Table 30Troubleshooting the 4-Slot Battery Charger(Continued)
163