User manual

Maintenance and Troubleshooting
IMPORTANT: If the battery connectors are exposed to cleaning agents, thoroughly wipe off as
much of the chemical as possible and clean with an alcohol wipe. It is also recommended to
install the battery in the terminal prior to cleaning and disinfecting the device to help minimize
buildup on the connectors. When using cleaning/disinfectant agents on the device, it is important
to follow the directions prescribed by the cleaning/disinfectant agent manufacturer.
Cleaning Frequency
The cleaning frequency is at the customer’s discretion due to the varied environments in which the mobile
devices are used and may be cleaned as frequently as required. When dirt is visible, it is recommended to
clean the mobile device to avoid the build-up of particles, which makes the device more difficult to clean
later on.
Device Cleaning Instructions
Do not apply liquid directly to the device. Dampen a soft cloth or use pre-moistened wipes. Do not wrap
the device in the cloth or wipe, instead gently wipe the unit. Be careful not to let liquid pool around the
display window or other places. Before use, allow the unit to air dry.
NOTE: For thorough cleaning, it is recommended to first remove all accessory attachments, such
as hand straps or cradle cups from the mobile device and to clean them separately.
Display
The display can be wiped down with an approved alcohol wipe, but care should be taken not to allow any
pooling of liquid around the edges of the display. Immediately dry the display with a soft, non-abrasive
cloth to prevent streaking.
Housing
Thoroughly wipe the housing, including all buttons and triggers, using an approved alcohol wipe.
Camera and Exit Window
Wipe the camera and exit window periodically with lens tissue or other material suitable for cleaning optical
material such as eyeglasses.
Cleaning Cradle Connectors
1. Remove the DC power cable from the cradle.
2. Dip the cotton portion of the cotton-tipped applicator in isopropyl alcohol.
3. Rub the cotton portion of the cotton-tipped applicator along the pins of the connector. Slowly move the
applicator back and forth from one side of the connector to the other. Do not leave any cotton residue
on the connector.
4. All sides of the connector should also be rubbed with the cotton-tipped applicator.
5. Remove any lint left by the cotton-tipped applicator.
6. If grease and other dirt can be found on other areas of the cradle, use a lint-free cloth and alcohol to
remove.
158