User manual

Application Deployment
5. If the device and host computer are connected for the first time, the Allow wireless debugging on this
network? dialog box with the Always allow from this network check box displays. Select the check
box, if required.
6. Touch ALLOW.
7. Touch Wireless debugging.
8. Touch Pair with pairing code.
The Pair with device dialog box displays.
9. On the host computer, navigate to the platform-tools folder and open a command prompt window.
10. Type adb pair XX.XX.XX.XX.XXXXX.
where XX.XX.XX.XX:XXXXX is the IP address and port number from the Pair with device dialog box.
11. Press Enter.
12. Type the pairing code fromthe Pair with device dialog box
13. Press Enter.
14. Type adb connect XX.XX.XX.XX:XXXXX.
where XX.XX.XX.XX:XXXXX is the IP address and port number from the Pair with device dialog box.
15. Press Enter.
The device is now connected to the host computer.
16. Type adb devices.
The following displays:
List of devices attached XXXXXXXXXXXXXXX device
Where XXXXXXXXXXXXXXX is the device number.
NOTE: If device number does not appear, ensure that ADB drivers are installed properly.
17. Type:
adb reboot recovery
150