User manual
Table Of Contents
- Contents
- About this Guide
- Getting Started
- Using the Device
- Settings
- Applications
- Data Capture
- Imaging
- Scanning Considerations
- Scanning with an Internal Scanner
- Scanning with the Camera
- Scanning with the RS507/RS507X Hands-Free Imager
- Scanning with the RS5100 Ring Scanner
- Scanning with the RS6000 Bluetooth Ring Scanner
- Scanning with the DS2278 Digital Scanner
- Scanning with the DS3678 Bluetooth Scanner
- Scanning with the DS8178 Digital Scanner
- Scanning with the LI3678 Linear Imager
- DataWedge
- Supported Decoders
- Camera Supported Decoders
- SE4100 Internal Imager Supported Decoders
- SE4710 Internal Imager Supported Decoders
- SE4720 Internal Imager Supported Decoders
- RS507/RS507x Supported Decoders
- RS5100 Supported Decoders
- RS6000 Supported Decoders
- DS2278 Supported Decoders
- DS3678 Supported Decoders
- DS8178 Supported Decoders
- LI3678 Supported Decoders
- Wireless
- Accessories
- Application Deployment
- Maintenance and Troubleshooting
- Technical Specifications
Application Deployment
5. If the device and host computer are connected for the first time, the Allow USB debugging? dialog
box with the Always allow from this computer check box displays. Select the check box, if required.
6. Touch OK.
7. On the host computer, navigate to the platform-tools folder and open a command prompt window.
8. Type adb devices.
The following displays:
List of devices attached XXXXXXXXXXXXXXX device
Where XXXXXXXXXXXXXXX is the device number.
NOTE: If device number does not appear, ensure that ADB drivers are installed properly.
9. Type:
adb reboot recovery
10. Press Enter.
The System Recovery screen appears on the device.
11. Press Volume Up and Volume Down buttons to navigate to Apply upgrade from ADB.
12. Press Power.
13. On the host computer command prompt window type:
adb sideload <file>
where: <file> = the path and filename of the zip file.
14. Press Enter.
The Factory Reset package installs and then the System Recovery screen appears on the device.
15. Press Power to reboot the device.
Performing a Factory Reset Using Wireless ADB
Perform a Factory Reset using Wireless ADB.
Go to the Zebra Support & Downloads web site at zebra.com/support and download the appropriate
Factory Reset file to a host computer.
IMPORTANT: Ensure the latest adb files are installed on the host computer.
IMPORTANT: The device and host computer must be on the same wireless network.
1. Go to Settings.
2. Touch System > Advanced > Developer options .
3. Slide the USB debugging switch to the ON position.
4. Slide the Wireless debugging switch to the ON position.
149