User manual
Table Of Contents
- Contents
- About this Guide
- Getting Started
- Using the Device
- Settings
- Applications
- Data Capture
- Imaging
- Scanning Considerations
- Scanning with an Internal Scanner
- Scanning with the Camera
- Scanning with the RS507/RS507X Hands-Free Imager
- Scanning with the RS5100 Ring Scanner
- Scanning with the RS6000 Bluetooth Ring Scanner
- Scanning with the DS2278 Digital Scanner
- Scanning with the DS3678 Bluetooth Scanner
- Scanning with the DS8178 Digital Scanner
- Scanning with the LI3678 Linear Imager
- DataWedge
- Supported Decoders
- Camera Supported Decoders
- SE4100 Internal Imager Supported Decoders
- SE4710 Internal Imager Supported Decoders
- SE4720 Internal Imager Supported Decoders
- RS507/RS507x Supported Decoders
- RS5100 Supported Decoders
- RS6000 Supported Decoders
- DS2278 Supported Decoders
- DS3678 Supported Decoders
- DS8178 Supported Decoders
- LI3678 Supported Decoders
- Wireless
- Accessories
- Application Deployment
- Maintenance and Troubleshooting
- Technical Specifications
Application Deployment
Android Enterprise Reset
An Enterprise Reset erases all user data in the /data partition, including data in the primary storage
locations (emulated storage).Zebra distributes the Enterprise Reset packages on the Zebra Support &
Downloads website.
Before performing an Enterprise Reset, provision all necessary configuration files and restore after the
reset.
Performing an Enterprise Reset Using ADB
Perform an Enterprise Reset using ADB.
Go to the Zebra Support & Downloads web site at zebra.com/support and download the appropriate
Enterprise Reset file to a host computer.
1. Connect the device to a host computer using a USB-C cable.
When transferring files or debugging, make sure there is only one USB connection to the device. For
example, if using a USB cable, do not dock the device or attach an expansion back.
2. Go to Settings.
3. Touch System > Advanced > Developer options .
4. Slide the USB debugging switch to the ON position.
5. If the device and host computer are connected for the first time, the Allow USB debugging? dialog
box with the Always allow from this computer check box displays. Select the check box, if required.
6. Touch OK.
7. On the host computer command prompt window type:
adb sideload <file>
where: <file> = the path and filename of the zip file.
8. Type adb devices.
The following displays:
List of devices attached XXXXXXXXXXXXXXX device
Where XXXXXXXXXXXXXXX is the device number.
NOTE: If device number does not appear, ensure that ADB drivers are installed properly.
9. Press Enter.
The System Recovery screen appears on the device.
10. Press Volume Up and Volume Down to navigate to Apply upgrade from ADB.
11. Press Power.
145