User manual
Table Of Contents
- Contents
- About this Guide
- Getting Started
- Using the Device
- Settings
- Applications
- Data Capture
- Imaging
- Scanning Considerations
- Scanning with an Internal Scanner
- Scanning with the Camera
- Scanning with the RS507/RS507X Hands-Free Imager
- Scanning with the RS5100 Ring Scanner
- Scanning with the RS6000 Bluetooth Ring Scanner
- Scanning with the DS2278 Digital Scanner
- Scanning with the DS3678 Bluetooth Scanner
- Scanning with the DS8178 Digital Scanner
- Scanning with the LI3678 Linear Imager
- DataWedge
- Supported Decoders
- Camera Supported Decoders
- SE4100 Internal Imager Supported Decoders
- SE4710 Internal Imager Supported Decoders
- SE4720 Internal Imager Supported Decoders
- RS507/RS507x Supported Decoders
- RS5100 Supported Decoders
- RS6000 Supported Decoders
- DS2278 Supported Decoders
- DS3678 Supported Decoders
- DS8178 Supported Decoders
- LI3678 Supported Decoders
- Wireless
- Accessories
- Application Deployment
- Maintenance and Troubleshooting
- Technical Specifications
Application Deployment
3. Scroll down to Build number.
4. Tap Build number seven times.
The message You are now a developer! appears.
5. Touch Back.
6. Touch System > Advanced > Developer options .
7. Slide the USB debugging switch to the ON position.
8. Touch OK.
9. Connect the device to the host computer using the Rugged Charge/USB Cable.
The Allow USB debugging? dialog box appears on the device.
If the device and host computer are connected for the first time, the Allow USB debugging? dialog
box with the Always allow from this computer check box displays. Select the check box, if required.
10. Touch OK.
11. Touch OK or Allow.
12. On the host computer, navigate to the platform-tools folder and open a command prompt window.
13. Type adb devices.
The following displays:
List of devices attached XXXXXXXXXXXXXXX device
Where XXXXXXXXXXXXXXX is the device number.
NOTE: If device number does not appear, ensure that ADB drivers are installed properly.
14. Return to the Home screen.
Entering Android Recovery Manually
Many of the update methods discussed in this section require putting the device into Android Recovery
mode. If you are unable to enter Android Recovery mode through adb commands, use the following steps
to manually enter Android Recovery mode.
1. Press and hold the Power button until the menu appears.
2. Touch Restart.
3. Press and hold the volume up button until theSystem Recovery screen appears.
Application Installation
After an application is developed, install the application onto the device using one of the supported
methods.
• Android Debug Bridge
• Wireless Android Debug Bridge
• USB connection
137