User manual
Table Of Contents
- Contents
- About this Guide
- Getting Started
- Using the Device
- Settings
- Applications
- Data Capture
- Imaging
- Scanning Considerations
- Scanning with an Internal Scanner
- Scanning with the Camera
- Scanning with the RS507/RS507X Hands-Free Imager
- Scanning with the RS5100 Ring Scanner
- Scanning with the RS6000 Bluetooth Ring Scanner
- Scanning with the DS2278 Digital Scanner
- Scanning with the DS3678 Bluetooth Scanner
- Scanning with the DS8178 Digital Scanner
- Scanning with the LI3678 Linear Imager
- DataWedge
- Supported Decoders
- Camera Supported Decoders
- SE4100 Internal Imager Supported Decoders
- SE4710 Internal Imager Supported Decoders
- SE4720 Internal Imager Supported Decoders
- RS507/RS507x Supported Decoders
- RS5100 Supported Decoders
- RS6000 Supported Decoders
- DS2278 Supported Decoders
- DS3678 Supported Decoders
- DS8178 Supported Decoders
- LI3678 Supported Decoders
- Wireless
- Accessories
- Application Deployment
- Maintenance and Troubleshooting
- Technical Specifications
Accessories
2. Push the device into the openīside of the handstrap.
Expansion Back
The Expansion Back provides a handstrap and Power Pack slot for the device.
NOTE: Not for use with ET4X-HC.
Installing the Expansion Back
CAUTION: Power off the device before installing or removing the Expansion Back.
CAUTION: Do not use any tool for battery cover removal. Puncturing the battery or seal may
cause a hazardous condition and a potential risk of injury.
1. Remove battery cover and store in safe place.
131