User's Manual

Appendix C. Agency Notices
Before a tablet PC model is available for sale to the public, it must be tested
and certified to the FCC and IC that it does not exceed the limit established by the
government-adopted requirement for safe exposure. The tests are performed
in positions and locations (e.g., next to body/lap) as required by the FCC for
each model. (next to body/lap
measurements may differ among tablet PC models,
depending upon available accessories and FCC and IC requirements). ”While there may be
differences between the SAR levels of various tablet PCs and at various positions, they are all
required to meet the government regulations for safe exposure. This device was evaluated and
shown to comply with FCC and IC SAR RF exposure requirements.
Avoid covering or holding antennas when transmitting. Antenna locations are
shown in the following figure.
Antennas
WLAN Bluetooth
antenna
Health and Safety Information
Exposure to Radio Frequency (RF) Signals
Your wireless tablet PC is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal Communications Commission of
the U.S. Government as well as the RTT&E directive. These limits are part of comprehensive
guidelines and
establish permitted levels of RF energy for the general population. The
guidelines are based on the safety standards previously set by both U.S. and
international standards bodies:
■
■
American National Standards Institute (ANSI) IEEE. C95.1-1992
National Council on Radiation Protection and Measurement (NCRP).
Report 86. 1986
36
iX101T1 User’s Handbook