User's Manual
Table Of Contents
- Contents
- Welcome
- Getting Started
- Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
- Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
- Contents
- Maintaining the Tablet
- Caring for the tablet. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .24
- Contents
- A
- B
- Troubleshooting
- Hardware Specifications
- C
- Agency Notices
- Disclaimer
- Trademarks
- MicroSD is registered trademark of the Personal
- Copyright
- Publication information
- Declaration of conformity
- Address: 14000 Summit Drive, Suite 900, Austin, Texas 78728
- This device complies with Part 15 of the FCC rules. Operation is subject to the
- This device must accept any interference received, including interference that may
- WARNING
- Changes or modifications to this unit not expressly approved by the party responsible for
- Warranty information
- Important safety information
- Before you use the iX101T1 (referred to as the tablet), read these safety
- Failure to observe all these instructions voids the Limited Warranty and may lead
- Operating the wireless-enabled tablet may interfere with the functioning of
- WARNING BATTERIES
- EXPLOSION HAZARD - DO NOT
- DISCONNECT EQUIPMENT UNLESS POWER HAS
- BEEN SWITCHED OFF OR THE AREA IS KNOWN
- TO BE NON-HAZARDOUS
- AVERTISSEMENT - RISQUE D'EXPLOSION -
- AVANT DE DECONNECTER L'EQUIPEMENT,
- COUPER LE COURANT OU S'ASSURER QUE
- L'EMPLACEMENT EST DESIGNE NON DANGEREUX.
- WARNING
- CAUTION
- Avoid prolonged physical contact with the exposed metal surfaces on the front and
- Welcome
- Welcome
- About your computer
- Tablet Model
- Touchscreen
- Projected Capacitive Touch (PCT)
- Control Method
- Welcome
- Package contents
- Welcome
- Optional accessories
- Your package may also include any optional accessories you ordered.
- Docking options
- Carrying cases
- Memory
- Additional accessories
- Welcome
- Contacting Xplore – service and questions
- Technologies Web site. Go to http://www.xploretech.com; then
- Web site
- Product name: iX101T1
- Getting Started
- Front view
- Built-in
- Front Camera
- Chapter 1. Getting Started
- Back view
- Camera Flash
- 5MP Camera
- Battery I/O Port Door
- Cover
- AC Power
- Expansion Bay Door
- Speaker
- NFC Reader
- AC Power
- Chapter 1. Getting Started
- Right side view
- Volume
- Down UP
- AC Power Connector Speaker
- Power (On/Off)/
- Power (On/Off)/
- Suspend (On/Off)/
- AC Power connector
- Chapter 1. Getting Started
- Left side view
- USB ports
- Power
- HDMI Input
- Audio
- WAN SIM
- The connectors on the side of the computer are located behind the outer doors.
- Audio connector
- USB 2.0 ports
- HDMI Output
- SD Card Slot
- Chapter 1. Getting Started
- Bottom view
- Docking connector for the
- Guide pin
- Docking connector
- Chapter 1. Getting Started
- LED Status indicator
- Table 1
- Mode/State
- LED State
- Meaning
- On state
- On Charging
- Off state
- Off Charging
- Chapter 1. Getting Started
- Table 1
- Mode/State
- On
- On
- LED State
- Meaning
- The computer is powered on, running on battery
- Chapter 1. Getting Started
- Quick-start guide
- First-Time Operation
- First time Turning on the computer
- Find and Turn the Battery switch ON. A small screwdriver or paperclip may be used for this purpose. For Safety reasons the tablet is shipped with the Battery switch OFF and the tablet will not operate if this step is not taken. It is not necess...
- Power On/Off,
- Chapter 2. Using the Tablet
- Turning on the computer
- Turning off the computer
- Chapter 2. Using the Tablet
- Suspending and resuming operation
- Suspend operation
- Resume operation
- Screen Input Operation
- Screen Input Operation
- C
- Maintaining the Tablet
- This chapter provides instructions for maintaining your tablet.
- Caring for the tablet
- Checking power cords and connectors
- Protecting the computer from damage
- Caring for the tablet
- Storing the computer
- Caring for the display screen
- Protecting the display screen
- Chapter 3. Maintaining the Tablet
- Removing the screen protector
- Installing a new screen protector
- Follow the instructions included with your screen protector
- A
- Table 7
- Problem
- Troubleshooting
- Computer will not start.
- The computer will not resume operation
- The Status LED is red, continuous.
- The Status LED is red, blinking.
- The computer is powered on, running under battery power, and the
- Appendix A. Troubleshooting
- Table 7
- Problem
- Possible cause and solution
- Display screen is blank or difficult to
- Headphone or speaker volume is too
- An external device is not working with
- B
- Physical
- Dimensions
- Weight
- Processing
- CPU
- Chip set
- OMAP4470 Dual core ARM A9
- Memory/storage
- Appendix B. Hardware Specifications
- Display
- Appendix B. Hardware Specifications
- Interface
- Power
- Main Battery
- Appendix B. Hardware Specifications
- Power (continued)
- Environmental
- Appendix B. Hardware Specifications
- 4”/hr, 40 mph wind and
- 7 gal/ft2/hr
- Agency approvals
- Appendix B. Hardware Specifications
- Operating system
- Operating Systems
- C
- Agency Notices
- FCC notices
- Note:
- This equipment has been tested and found to comply with the limits for
- WLAN: (Wi-Fi)
- Please note that 5150-5250MHz (ch. 36-48) is restricted to indoor-use only in many countries including the United States.
- RF exposure
- Appendix C. Agency Notices
- Antennas
- WLAN Bluetooth
- Health and Safety Information
- Exposure to Radio Frequency (RF) Signals
- Appendix C. Agency Notices
- Note:
- In the U.S. and Canada, the SAR limit for mobile tablet PCs used by
- DOC (Industry Canada Notices)
- Notice to Users of Radio and Television
- Appendix C. Agency Notices
- UL Notice
- This unit requires an AC adapter to operate. Use only UL Listed
- For authorized repair technicians only
- WARNING
- WARNING
- System disposal
A
Table 7
Problem
Troubleshooting
Table 7 contains solutions to some problems. If you cannot solve the
problem by taking the actions described, contact your local help desk
or your reseller for further assistance.
Troubleshooting
Possible cause and solution
Computer will not start.
The computer will not resume operation
after being suspended.
The Status LED is red, continuous.
The Status LED is red, blinking.
iX101T1 User’s Handbook
· The battery may be defective or discharged to a critically low level.
Connect an external power supply (such as the AC adapter) or install
a charged battery. See “Using the battery” on page 54.
· Internal components may be above or below the acceptable
operating range (below -20° C or above 60° C). After the
temperature returns to safe operating range the computer will start.
· The battery may be defective or discharged to a critically low level.
When the battery reaches a critically low level, the computer is
forced into Suspend- to-RAM mode to avoid a total system power
failure. Connect an external power supply (such as the AC adapter)
or install a charged battery. See “Using the battery” on page 54.
· The computer may be at the critical thermal limit. To avoid damage
to heat-sensitive components, the computer enters Suspend-to-
RAM mode when the computer operates above 60° C. Operation
automatically resumes when the computer cools to below 60° C.
Move the computer to a cooler location.
· The computer is on, running under battery power, and the charge
level in the battery has reached a critical level. Plug the computer
into an AC/DC power source or install a charged battery.
· The system has encountered a fault and is preventing normal
operation. Contact your local help desk.
The computer is powered on, running under battery power, and the
charge level in the battery is at a minimum warning level. Plug the
computer into an AC/DC power source or install a charged battery.
27