User's Manual

ManualsBrandsXplore Technologies ManualsElectronicsCELLULAR/PCS GSM/EDGE/WCDMA/CDMA+ 700 MHz LTE MODEM

Table Of Contents

Important Notice
Safety and Hazards
Limitation of Liability
Patents
Copyright
Trademarks
Contact Information
Revision History
1: Introduction
- Supported RF bands
- Physical features
- Application interface features
- Packet mode features
- LTE features
- Short Message Service (SMS) features
- Position location (GPS)
- Warranty and support
- Supporting documents
- Accessories
- Required connectors
- Ordering information
- Integration requirements
2: Technology Overview
- LTE
- CDMA
  - 1xEV-DO
  - 1X and IS-95A
3: Standards Compliance
4: Electrical Specifications
- Host interface pin assignments
- Power supply
- USB interface
  - USB high / full speed throughput performance
  - User-developed drivers
- SIM interface
  - SIM implementation
- Control interface (Signals)
  - W_DISABLE_N — Wireless disable
  - WLAN_LED_N — LED output
- Digital interface
5: RF Specifications
- RF connections
  - Shielding
  - Antenna and cabling
- Ground connection
- Interference and sensitivity
- Radiated sensitivity measurement
  - Sierra Wireless’ sensitivity testing and desensitization investigation
  - Sensitivity vs. frequency
- Supported frequencies
- Conducted Rx sensitivity / Tx power
- GPS specifications
6: Power
- Power consumption
- Module power states
  - Power state transitions
- Power interface
7: Software Interface
- Support tools
- USB interface
- TCP window size (Windows XP)
8: Mechanical and Environmental Specifications
- Device views
- Labeling
  - Electrostatic discharge (ESD)
- Thermal considerations
9: Regulatory and Industry Approvals
- Important notice
- Safety and hazards
- Important compliance information for North American users
- OEM integration
  - Application of regulatory guidelines
  - OEM device classification process
A: Antenna Specification
- Recommended GPS antenna specifications
- Antenna tests
B: Design Checklist
C: Testing
- AT command entry timing requirement
- Acceptance testing
  - Acceptance test requirements
  - Acceptance test procedure
- Certification testing
- Production testing
- Functional production test
- Quality assurance testing
- Suggested testing equipment
- Testing assistance provided by Sierra Wireless
- IOT/Operator testing
- Extended AT commands for testing
D: Packaging
E: References
- Web site support
- Sierra Wireless documents
F: Acronyms
Index

Product Technical Specification & Customer Design Guidelines

68 Proprietary and Confidential - Contents subject to change 2400074

• Any metallic part of the antenna system that is exposed to the outside

environment needs to meet the electrostatic discharge tests per IEC61000-4-

2 (conducted discharge +8kV).

• The functional requirements of the antenna system are tested and verified

while the embedded module’s antenna is integrated in the host device.

Note: Additional testing, including active performance tests, mechanical, and accelerated

life tests can be discussed with Sierra Wireless’ engineering services. Contact your Sierra

Wireless representative for assistance.