User Manual

7-18
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows
OL-1394-06
Chapter 7 Performing Diagnostics
Running an RF Link Test
The following prerequisites are required before you can run an RF link test:
• The TCP/IP protocol must be installed on your system.
Note See the Help section of your Windows operating system for information on installing and
setting up TCP/IP.
• An IP address must be configured for the access point (or other computer in ad hoc mode).
Follow the steps below to run an RF link test.
Step 1 Open ACU; then click the Link Test icon or select Linktest from the Commands drop-down menu. The
Linktest screen appears (see Figure 7-6).
Note The name of the current profile appears in parentheses at the top of the screen.
Figure 7-6 Linktest Screen