User's Manual

Chapter 2. Using the Tablet
XC6 User’s Handbook 48
Accessing the Solid State Drive (SSD) cartridge
When you install a new storage drive, follow the instructions in this
section to access the hard drive carrier.
WARNING Failure to follow this procedure can result in damage
to the case and the cover, which is not covered under
the Xplore Technologies warranty. Xplore
recommends that you use an
approved Xplore Technologies service center for
this procedure.
1. Turn off the computer.
2. Remove all power from the unit, including batteries and other power
sources such as power supplies, cigarette lighter adapters, and
mobile power sources.
3. Pinch the two center pins with one hand while pushing down on the
lever with the other. The drive carrier will pop up (like the battery)
and permit removal.
Note: Your drive carrier may have two screws installed. If so,
remove them before you exchange the drive carrier.